Trigger/gate delay module for Eurorack / Doepfer A100 system

From top:
Trig/gate input
Button + LEDs for original (“dry”) mixing to output (no/1/2/both by short press) and time range setting (long press)
Delay time 1
Delay time 2 + CV control input
Out1 (here are both outputs mixed if no jack is plugged into out2)
Out2

Basic delay time 0 to 4s can be shortened to 0-1,3s by holding button. Another button hold switches time back to 0-4s.
Resolution (shortest trigger) is 0,7ms.
These time settings can be tripled if internal jumper is set so time range is 0-12s and 0-4s with 2ms resolution.

There can be an “non-rhytmic” output at moment of changing delay time. Memory is read at different ratio (faster or slower) to ensure no trig/gate is lost. If delaytime change is made with active trigger/gate this trigger/gate can be held active for a while (until desired delay time is reached).

Imagine an tape recorder with fixed tape speed and recording and play heads in some distance (=set delay time). If distance is increased delay time increases too, if distance is lowered delay time is shorted.
At time of head movement there can be “non-rhytmic” artifacts because play head meets recorded triggers more often (than they was recorded) and play them at higher speed (and they may be shorted too of course).
If time is increased (play head is moved away from rec head almost with tape) and at this moment is recorded gate present this gate will be played for longer time than was recorded.
Because there is limited speed of “head movement” (speed of delay time change) delay time cannot be changed abruptly. This ensures all recorded trig/gates will be played (no one will be skipped or lost).

Width: 4TE/ 4HP/ 20mm
Depth: 40mm /1,6″ max.
Current: 25mA (from positive supply only)
Power cable included

Double check power connection before powering your system please.
„Red strip“ means -12V connector side in Eurorack standards.
In some power distribution systems connector key can be reverted.
In this case cut connector key and plug power connector right way (with respect to red strip) or use different power cable appropriate to your power system.