S-195 Microdelay module for Eurorack / Doepfer A100 system. NOT PURPOSED FOR AUDIO.
From the top down:
four input jacks
three position switch (delay time setting)
four output jacks
S-195 Microdelay is four-channel module delaying input trigs and/or gates. Delay time can be set to 1ms/2ms/5ms or 100us/200us/500us using three position switch (same delay time for all four channels). Milliseconds or microseconds time range is set by internal jumper, jumper header set = 1/2/5 millisecs, jumper header removed = 100/200/500 microsecs. This module can solve an problems with concurrent trigs and/or gates (some equipment doesn´t works correctly if say clock and reset appears at same time so delaying one of signals can help). Input jacks are normalled so one input can be delayed and multed to more outputs. Serial channel patching allows to reach even longer delay times.
There is hidden function allowing four different delay times for channels. Delays then are 100us/200us/500us/1ms in left switch position, 200us/500us/1ms/2ms in mid switch position and 500us/1ms/2ms/5ms in right switch position. To activate this mode desolder two-leg bridge/short on board (black marked on board). Onboard jumper setting has no effect in this mode.
Width: 4TE/ 4HP/ 20mm
Depth: 40mm /1,6″ max.
Current: 25mA max.
Power cable included
Double check power connection before powering your system please.
„Red strip“ means -12V connector side in Eurorack standards.
In some power distribution systems connector key can be reverted.
In this case cut connector key and plug power connector right way (with respect to red strip) or use different power cable appropriate to your power system.