R-110 “Random clocked trigs/gates w. disable input” module for eurorack / Doepfer A100 system.
Disable input jack + LED (if active, gate outputs stays in its current state or are all switched off – selectable by internal jumper)
Clock input jack + LED
Trig 1/2/3 output jacks and LEDs (probability = 3 so in average every third input clock makes output trigger)
Gate 1/2/3 output jacks and LEDs (probability = 3 so in average every third clock makes gate on and then every third clock makes gate off)
Configurable parameters (by internal jumpers, just one of first five should be set):
a) jumper 1: fixed 1ms trig outputs
b) jumper 2: fixed 200ms trig outputs
c) jumper 3: variable trigger outputs length – quarter of input gate length
d) jumper 4: variable trigger outputs length – half of input gate length
e) jumper 5: variable trigger outputs length – equal to input gate length
f) independent „disable“ jumper (behind T1 output jack): gate outputs stays in its current state (jumper not set ) or are all switched off (jumper set) at active “disable” input signal
P-060 – switches can be used for switching from front panel.
Width: 4TE/ 4HP/ 20mm.
Depth: 40mm /1,6″ max.
Current: 15mA max.
Power cable included.
Double check power connection before powering your system please.
“Red strip” means -12V connector side in Eurorack standards.
In some power distribution systems connector key can be reverted.
In this case cut connector key and plug power connector right way (with respect to red strip) or use different power cable appropriate to your power system.