S-075 Burst generator module for Eurorack / Doepfer A100 system

From top:
Number of bursts knob + CVin jack, LED lights at odd numbers
Spacing knob + CVin jack
Trigger/gate input + LED
Gate output + LED
Burst output + LED

Internal jumper settings:
upper rear jumper sets number of bursts to 1-8 bursts (jumper removed) or to 0-8 bursts (jumper set)
lower rear jumper sets output trigger/gate length to fixed 2ms (jumper removed) or to half of spacing (jumper set)
separate jumper sets max. spacing time to 2s (fast mode – jumper removed) or to 8s (slow mode – jumper set)

Min. spacing about 3ms (8 bursts pass in about 20ms) in fast mode or 10ms (8 bursts pass in about 75ms) in slow mode
Max. spacing 2s (8 bursts pass in about 16s) in fast mode or 8s (60s for 8 bursts) in slow mode
Max. burst-on time 1s (1/2 of spacing in fast mode) or 4s (1/2 of spacing in slow mode)

Gate output jack is active while burst is passing (20ms to 16s in fast mode, 75ms to 60s in slow mode).
Rising edge of input restarts new burst if current burst is still passing.
Knobs works as attenuators for input CV if jack is plugged in.

Width: 4TE/ 4HP/ 20mm
Depth: 40mm /1,6″ max.
Current: 25mA (from positive supply only)
Power cable included

Double check power connection before powering your system please.
„Red strip“ means -12V connector side in Eurorack standards.
In some power distribution systems connector key can be reverted.
In this case cut connector key and plug power connector right way (with respect to red strip) or use different power cable appropriate to your power system.